2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 1758
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P15F2
- Engine Torque Command Circuit
Circuit/System Description
This diagnostic applies to internal microprocessor integrity conditions within the engine control module (ECM). The hybrid powertrain control
module (HPCM) sends an engine torque requested message to the ECM over GMLAN. The ECM monitors the data to verify that the indicated
engine torque requested calculation is correct. The ECM processor monitors the data to verify that the engine torque command is correct.
Conditions for Running the DTC
* The control module runs the program to detect an internal fault when the key is ON.
* Ignition voltage is 8-18V.
* DTC U1817 is not set.
Conditions for Setting the DTC
The control module has detected an internal malfunction.
Action Taken When the DTC Sets
* DTC P15F2 is a Type A DTC.
* The HPCM commands the battery energy control module (BECM) to open the high voltage contactor relays.
Conditions for Clearing the DTC
DTC P15F2 is a Type A DTC.
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Circuit/System Verification
1. Clear the DTC information.
2. Ignition OFF for 1 minute.
3. Ignition ON.
4. Retest for DTC P15F2.
Circuit/System Testing
Important: Diagnose and repair any communication DTCs prior to performing this testing.
Program the engine control module (ECM) with the latest software version and recheck for DTCs.
If the DTC resets after programming or if the ECM already contains the latest software version, replace the ECM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming.
Without 6.0L or 6.2L
DTC P0016 (Without 6.0L or 6.2L)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
