Wednesday, October 30, 2019

2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 1615

2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 1615

DTC P1AF8

- Drive Motor 1 Control Module Shutdown Performance

DTC P1AFE

- Drive Motor 2 Control Module Shutdown Performance

Circuit/System Description

The drive motor generator power inverter control module (PIM) contains two motor control modules (MCMs) and the hybrid powertrain control

module (HPCM). Each MCM operates its respective drive motor generator based upon HPCM commands. Each MCM controls the speed, direction

and output torque of its respective drive motor generator through the sequencing actuation of high current switching transistors called insulated gate

bipolar transistors (IGBTs). Each drive motor generator operates utilizing 3 phase alternating current (ac) electricity. Each IGBT operates a single

phase of the drive motor generator. Each phase is individually identified as U, V and W. Each MCM monitors the current of each phase in order to

detect PIM overcurrent conditions.

At ignition ON, each MCM tests the integrity of the drive motor phase circuits by sequencing the IGBTs between open and shorted states while

simultaneously injecting a large amount of current into the phase circuits. The individual phase current sensors should all indicate similar current

flow and the current flow should increase and decrease at known rates based upon the inductance of the drive motor.

Conditions for Running the DTC

* The ignition is transitioned to ON.

* Ignition voltage is 8-18 volts.

* High voltage has been enabled.

Conditions for Setting the DTC

The control module has detected a phase current that indicates an open or shorted 3 phase circuit condition exists.

Action Taken When the DTC Sets

* DTCs P1AF8 and P1AFE are Type A DTCs.

* The HPCM commands the battery energy control module (BECM) to open the high voltage contactor relays.

Conditions for Clearing the DTC

DTCs P1AF8 and P1AFE are Type A DTCs.

Diagnostic Aids

* An intermittent loss of battery power to the drive motor generator power inverter control module (PIM) may set this DTC.

* An open or shorted 3 phase circuit, prior to ignition ON, may set this DTC.

Reference Information

Schematic Reference

Hybrid Controls Schematics ()

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Circuit/System Verification

1. Clear the DTC information.

2. Turn the ignition OFF for 1 minute.

3. Turn the ignition ON.

4. Retest for DTC P1AF8 or P1AFE.

Circuit/System Testing

1. Verify that DTCs P0C01, P0C04, P0BFD, or P0BFE is not set.

锟斤拷If the DTC is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic

Trouble Code (DTC) List - Vehicle).

Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection.

Personal Protection Equipment (PPE) and proper procedures must be followed.