2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1036
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector of the ESC module.
2. Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 ohms between the ground
circuit terminal 47 and ground.
瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.
3. Verify that a test lamp illuminates between the 12V B+ circuit terminal 32 of the ESC module and ground.
瀚慖f the test lamp does not illuminate, test the 12V B+ circuit for a short to ground or an open/high resistance.
4. If all circuits test normal, replace the ESC module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for ESC module replacement, setup and programming.
PSCM
DTC C0895 (PSCM)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC C0895 03
- Device Voltage Below Threshold - PSCM 42V
DTC C0895 07
- Device Voltage Above Threshold - PSCM 42V
DTC C0895 12
- Device Voltage Below Minimum Threshold - PSCM 42V
Diagnostic Fault Information
Typical Scan Tool Data
