2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 336
瀚慖f the indicator does not illuminate when tested or the incorrect indicator illuminates, replace the TCSCS.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Transfer Case Shift Control Switch Replacement (Without SLT) (See: Powertrain Management/Transmission Control Systems/Sensors and
Switches - Transmission and Drivetrain/Sensors and Switches - Transfer Case/Four Wheel Drive Selector Switch/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for TCSCM replacement, setup, and programming
* Transfer Case High/Low Clutch Reset (See: Transmission and Drivetrain/Transfer Case/Testing and Inspection/Symptom Related
Diagnostic Procedures/MP 3023/3024-NQH - Transfer Case/Transfer Case High/Low Clutch Reset)
MP 3023/3024-NQH - Transfer Case
DTC B0775
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B0775 01
- 4WD HI Indicator Circuit Short to Battery
DTC B0775 06
- 4WD HI Indicator Circuit Short to Ground or Open
Diagnostic Fault Information
Circuit/System Description
The 4WD HI indicator circuit consists of a light emitting diode (LED) feed circuit, a LED and a LED control circuit. The indicator dimming control
circuit is the LED feed circuit and continuously supplies B+ to the 2WD HI, 4WD Auto, 4WD HI and 4WD LO LEDs. When the 4WD HI mode
has been selected by the driver, the transfer case shift control module (TCCM) provides a ground through the 4 HI indicator control circuit
illuminating the LED.
The TCCM tests the 4WD HI indicator circuit for unexpected voltage by monitoring the B+ supplied by the BCM on the indicator dimming control
circuit by grounding the 4WD HI indicator control circuit for 2 seconds during the Bulb Test at key ON.
Conditions for Running the DTC
B0775 01
* Ignition ON
* System voltage 10-18 V
* Instrument panel lights not dimmed.
* Daylight running lights MUST be commanded ON.
* Circuit tested when the 4WD HI indicator is commanded ON.
Diagnostic Repair parts ,Wiring Diagrams. DTC. TSB,Car, Truck, SUV & Van Acura Chrysler Infiniti Maserati Rolls-Royce Alfa Romeo Dodge Jaguar Mazda Scion Aston Martin Ferrari Jeep McLaren Smart Audi Fiat Karma Mercedes-Benz Spyker BMW Ford Kia Mini Subaru Bentley Freightliner Lamborghini Mitsubishi Tesla Bugatti GMC Land Rover Mobility Ventures Toyota Buick Genesis Lexus Nissan Volkswagen Cadillac Honda Lincoln Porsche Volvo Chevrolet Hyundai Lotus Ram