2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 350
* Transfer Case Shift Control Switch Replacement (Without SLT) (See: Powertrain Management/Transmission Control Systems/Sensors and
Switches - Transmission and Drivetrain/Sensors and Switches - Transfer Case/Four Wheel Drive Selector Switch/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for TCSCM replacement, setup, and programming
* Transfer Case High/Low Clutch Reset (See: Transmission and Drivetrain/Transfer Case/Testing and Inspection/Symptom Related
Diagnostic Procedures/MP 3023/3024-NQH - Transfer Case/Transfer Case High/Low Clutch Reset)
B0790
DTC B0790
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B0790 01
- Neutral Indicator Circuit Short to Battery
DTC B0790 06
- Neutral Indicator Circuit Short to Ground or Open
Diagnostic Fault Information
Circuit/System Description
The Neutral indicator circuit consists of a light emitting diode (LED) feed circuit, a LED and a LED control circuit. The Ignition 1 voltage circuit is
the LED feed circuit and continuously supplies B+ to the Neutral LED. When the Neutral mode has been selected by the driver, the transfer case
shift control module (TCCM) provides a ground through the Neutral indicator control circuit illuminating the LED.
The TCCM tests the Neutral indicator circuit for unexpected voltage by monitoring the B+ supplied by the BCM on the Ignition 1 voltage circuit by
grounding the Neutral indicator control circuit for 2 seconds during the Bulb Test at key ON.
Conditions for Running the DTC
B0790 01
* Ignition ON
* System voltage 10-18 V
* Instrument panel lights not dimmed.
* Daylight running lights MUST be commanded ON.
* Circuit tested when the Neutral indicator is commanded ON.
B0790 06
* Ignition ON
* System voltage 10-18 V
* Instrument panel lights not dimmed.
* Daylight running lights MUST be commanded ON.
* Circuit tested when the Neutral indicator is commanded OFF.
Conditions for Setting the DTC
B0790 01
The TCCM detects 3.4 V or greater on the AWD/4WD Auto indicator control circuit when the Neutral indicator is commanded ON.
B0790 06
The TCCM detects 1.6 V or less for 1.5 seconds on the AWD/4WD Auto indicator control circuit when the Neutral indicator is commanded OFF.
Diagnostic Repair parts ,Wiring Diagrams. DTC. TSB,Car, Truck, SUV & Van Acura Chrysler Infiniti Maserati Rolls-Royce Alfa Romeo Dodge Jaguar Mazda Scion Aston Martin Ferrari Jeep McLaren Smart Audi Fiat Karma Mercedes-Benz Spyker BMW Ford Kia Mini Subaru Bentley Freightliner Lamborghini Mitsubishi Tesla Bugatti GMC Land Rover Mobility Ventures Toyota Buick Genesis Lexus Nissan Volkswagen Cadillac Honda Lincoln Porsche Volvo Chevrolet Hyundai Lotus Ram