2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 558
1. Ignition OFF, disconnect the X2, X5 harness connectors at the MSM.
2. Test for 850 Ohms - 300 kOhms between the signal circuit terminal 2 X5 and the low reference circuit terminal 6 X2.
瀚慖f less than the specified range, test for a short between the signal and low reference circuits. If the circuits test normal, replace the seat
cushion heater element/temperature sensor.
瀚慖f greater than the specified range, test the signal and low reference circuits for a short to voltage or an open/high resistance. If the circuits
test normal, replace the seat cushion heater element/temperature sensor.
3. Connect the X2, X5 harness connectors at the MSM.
4. Disconnect the harness connector at the seat cushion heater element/temperature sensor.
5. Ignition ON, test for 4.8 - 5.2 V between the signal circuit terminal C and ground.
瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the MSM.
瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the MSM.
6. If all circuits test normal, replace the MSM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Driver or Passenger Seat Cushion Heater Replacement (without HP2) ()Driver or Passenger Seat Cushion Heater Replacement (with HP2)
()
* Control Module References (See: Testing and Inspection/Programming and Relearning) for the MSM replacement, setup, and programming
Dealer Installed
DTC B1935 or B2180 (Dealer Installed)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B1935 04
- Left Seat Back Heater Circuit Open
DTC B1935 0A
- Left Seat Back Heater Circuit Rate of Change Below Threshold
DTC B1935 0B
- Left Seat Back Heater Circuit Current Above Threshold
DTC B1935 0C
- Left Seat Back Heater Circuit Current Below Threshold
DTC B1935 0D
- Left Seat Back Heater Circuit Resistance Above Threshold
DTC B1935 0E
- Left Seat Back Heater Circuit Resistance Below Threshold
DTC B1935 1F
- Left Seat Back Heater Circuit Intermittent
DTC B2180 04
- Right Seat Back Heater Circuit Open
DTC B2180 0A
- Right Seat Back Heater Circuit Rate of Change Below Threshold
DTC B2180 0B
- Right Seat Back Heater Circuit Current Above Threshold
