2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 870
The solenoid relay, located within the electronic brake control module (EBCM), supplies battery voltage to all of the valve solenoids.
Conditions for Running the DTC
* Ignition voltage is greater than 9.5 volts.
* The solenoid relay is commanded ON.
Conditions for Setting the DTC
One or more of the following conditions exists:
* The EBCM detects an open in the battery positive voltage circuit to the solenoid valve relay.
* The EBCM detects a stuck open solenoid valve relay or an open circuit between the solenoid valve relay and solenoid valves.
Action Taken When the DTC Sets
* The EBCM disables the antilock brake system (ABS), traction control system, and the dynamic rear proportion for the duration of the
ignition cycle.
* The ABS indicator turns ON.
* The Traction Control indicator turns ON.
* The red Brake Warning indicator turns ON.
* The driver information center displays the SERVICE BRAKE SYSTEM/TRACTION SYSTEM message.
Conditions for Clearing the DTC
* The condition for setting the DTC is no longer present.
* The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.
Reference Information
Schematic Reference
Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation/ABS
Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool EBCM Battery Voltage Signal parameter. The reading should be battery voltage.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the EBCM.
2. Test for less than 1 ohm between the ground circuits listed below and ground.
* Terminal 1
* Terminal 25
瀚慖f greater than the specified range, test the ground circuits for an open/high resistance.
3. Ignition ON, verify that a test lamp illuminates between the B+ circuits listed below and ground.
