Friday, November 15, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1114

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1114



DTC Descriptors



DTC P0135



- HO2S Heater Performance Sensor 1



DTC P0141



- HO2S Heater Performance Sensor 2



Diagnostic Fault Information



Circuit Description



The heated oxygen sensor (HO2S) heater reduces the time required for the oxygen sensor to reach operating temperature and maintains the



operating temperature during extended idle periods. When the ignition is turned to the ON position, ignition voltage is supplied directly to the



sensor heater. The engine control module (ECM) controls the heater operation by first modulating the control circuit to ground when the sensors are



cold. This prevents the possibility of thermal shock to the sensor, from condensation build-up on the sensor, by controlling the sensor's rate of



heating. After a predetermined amount of time, the ECM commands the heaters ON continuously. Once the sensor reaches operating temperature,



the ECM may modulate the heater control circuit to ground to maintain a desired temperature. The ECM controls the heater by grounding the



control circuit with a solid state device called a driver. The driver is equipped with a feedback circuit that is pulled up to voltage. The ECM can



determine if the control circuit is open, shorted to ground, or shorted to a voltage by monitoring the feedback voltage.



Conditions for Running the DTC



P0135



* Before the ECM can report DTC P0135 failed, P0030, P0031, and P0032 must run and pass.



* DTC P0130, P0131, P0132, or P0134 is not set.



* The engine is operating.



* The ignition voltage is 10-18 volts.



* The intake air temperature (IAT) is greater than -30掳C (-22掳F).



* After the previous ignition cycle the engine OFF time was greater than 2 minutes.



* The calculated exhaust temperature is less than 524掳C (975掳F).



* The engine is not in decel fuel cut-off (DFCO).



* The HO2S 1 is at operating temperature for greater than 10 seconds.



* The internal HO2S 1 resistance is less than 10,000 ohm.



* DTCs P0135 runs continuously once the above conditions are met for approximately 100 seconds.



P0141



* Before the ECM can report DTC P0135 and P0141 failed, DTCs P0036, P0037, and P0038 must run and pass.



* DTCs P0137, P0138, or P0140 are not set.



* The engine is operating.



* The ignition voltage is 10-18 volts.



* The intake air temperature (IAT) is greater than -30掳C (-22掳F).



* After the previous ignition cycle the engine OFF time was greater than 0 seconds.



* The calculated exhaust temperature is 360-500掳C (680-932掳F).



* The engine is not in decel fuel cut-off (DFCO).



* The internal HO2S 2 resistance is less than 10,000 ohm.



* The HO2S 2 heater is enabled for greater than 120 seconds.



* DTCs P0135 and P0141 run continuously once the above conditions are met for approximately 100 seconds.



Conditions for Setting the DTC



The ECM detects that the internal resistance of an HO2S 1 or HO2S 2 heater is not within the expected range.



Action Taken When the DTC Sets



DTCs P0135 and P0141 are Type B DTCs.



Conditions for Clearing the MIL/DTC



DTCs P0135 and P0141 are Type B DTCs.