Monday, December 2, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 626

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 626

1. Ignition OFF, disconnect the harness connector at any component with inoperative courtesy lighting.

2. Ignition OFF, scan tool disconnected, interior lamps OFF, doors CLOSED, test for less than 5 ohm between the ground circuit and ground.

瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.

3. Connect a test lamp between the control circuit and ground.

4. Command the Courtesy Lamp control ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the

commanded states.

瀚慖f the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the BCM.

瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.

5. If all circuits test normal, replace the component with the inoperative backlighting.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Dome Lamp Replacement (See: Lighting and Horns/Dome Lamp/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for driver or passenger door switch replacement,

setup, and programming

B2575

DTC B2575

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC 2575 00

- Headlamp Control Circuit

Diagnostic Fault Information

Circuit/System Description