Sunday, December 1, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 590

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 590

If the antenna assembly is damaged, replace the cellular antenna.

Circuit/System Testing

Note: The vehicle may be equipped with sectioned coax. Test each section and replace only the faulty section, not the entire length of coax.

1. Ignition OFF, disconnect the cellular antenna coax from the CIM module and the cellular antenna.

2. Ignition ON, test for less than 1 volt between the antenna coax center terminal and ground.

瀚慖f greater than the specified range, replace the antenna coax.

3. Ignition ON, test for less than 1 volt between the antenna coax outer shield and ground.

瀚慖f greater than the specified range, replace the antenna coax.

4. Test for infinite resistance between the antenna coax center terminal and ground.

瀚慖f less than the specified value, replace the antenna coax

5. Test for infinite resistance between the antenna coax outer shield and ground.

瀚慖f less than the specified value, replace the antenna coax

6. Test for less than 5 ohms at the cellular antenna coax center terminal from end to end.

瀚慖f greater than specified value, replace the cellular antenna coax cable.

7. Test for less than 5 ohms at the cellular antenna coax outer shield from end to end.

瀚慖f greater than specified value, replace the cellular antenna coax cable.

8. Test for infinite resistance between the antenna coax center terminal and the outer shield.

瀚慖f less than specified value, replace the cellular antenna coax cable.

9. If coax cable tests normal, replace the cellular antenna.

10. Clear the DTCs and operate the vehicle within the conditions for running the DTC. Verify DTC B2470 does not set.

瀚慖f the DTC sets, replace the CIM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Cellular Communications/Digital Radio Antenna Replacement (See: Accessories and Optional Equipment/Antenna/Antenna, Radio/Service

and Repair/Cellular Communications/Digital Radio Antenna Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for CIM replacement, setup, and programming

B2474

DTC B2474

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B2474 07

- Navigation Display Head Backlighting Performance