Thursday, December 5, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 684

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 684

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Front Side Door Window Regulator Motor Replacement (See: Windows and Glass/Windows/Service and Repair/Front Side Door Window

Regulator Motor Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for DDS and PDS replacement, setup, and

programming

B3265

DTC B3265

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B3265 00

- Trunk/Hatch/Liftglass Release Output Circuit

Diagnostic Fault Information

Circuit/System Description

The liftglass release switch is an input to the body control module (BCM). The BCM supplies battery voltage to the signal circuit and when the

release switch is activated the signal circuit voltage goes low. The BCM controls the liftglass release actuator through the rear wiper motor control

module. When the release switch signal is activated the BCM applies battery voltage to the liftglass latch release signal circuit. The rear wiper

motor control module supplies voltage to the release actuator through the liftglass release actuator control circuit.

Conditions for Running the DTC

* System voltage must be 9-16 volts.

* The liftglass release operation is commanded.

Conditions for Setting the DTC

The BCM detects a fault in the liftglass release signal circuit.

Action Taken When the DTC Sets

The liftglass latch will be inoperative for as long as the fault is present.

Conditions for Clearing the DTC

* The DTC will be current for as long as the fault is present.

* When the fault is no longer present, the DTC will be a history DTC.

* A history DTC will clear after 50 ignition cycles.