Thursday, December 19, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1346

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1346



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Circuit/System Testing



1. Engine idling, observe the DTC information with a scan tool. Verify there are no HO2S or misfire DTCs set.



瀚慖f any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code



Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle) to diagnosis the applicable DTC, before proceeding with this diagnostic



procedure.



2. Verify the following conditions do not exist with the catalytic converter:



* Dents



* A severe discoloration caused by excessive temperatures



* Road damage



* An internal rattle caused by damaged catalyst substrate



* Restrictions



瀚慖f a condition is found, replace the catalytic converter.



3. Verify the following conditions do not exist with the exhaust system:



* Leaks



* Physical damage



* Loose or missing hardware



* Properly torqued HO2S



瀚慖f a condition is found, repair the exhaust system.



4. Verify the following conditions do not exist with the HO2S 2:



* A grounded wiring harness



* Damage



瀚慖f a condition is found, replace the HO2S 2.



5. If no physical condition is detected and the HO2S 2 is as active as the HO2S 1 after operating the engine at 1,500 RPM for 1 minute and then



returning to a stabilized idle, then replace the catalytic converter.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Exhaust Leakage (See: Engine, Cooling and Exhaust/Exhaust System/Testing and Inspection/Exhaust Leakage)



* Restricted Exhaust (See: Engine, Cooling and Exhaust/Exhaust System/Testing and Inspection/Restricted Exhaust)



* Heated Oxygen Sensor Replacement - Bank 1 Sensor 2 (LF1) ()



* Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 (LF1) ()



* Catalytic Converter Replacement - Left Side (LF1) ()



* Catalytic Converter Replacement - Right Side (LF1) ()



P0430



DTC P0420 or P0430



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptor



DTC P0420



- Catalyst System Low Efficiency Bank 1