Monday, January 13, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1467

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1467



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for engine control module replacement, setup, and



programming



P0610



DTC P0602-P0606, P0610, P0614, P0630, P06D1, P160D, P160E, P161C, or P2610 (ECM, LAU/LBW)



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0602



- Control Module Not Programmed



DTC P0603



- Control Module Long Term Memory Reset



DTC P0604



- Control Module Random Access Memory Performance



DTC P0605



- Control Module Programming Read Only Memory Performance



DTC P0606



- Control Module Processor Performance



DTC P0610



- Control Module Vehicle Options Incorrect



DTC P0614



- Engine Control Module/Transmission Control Module Programming Not Plausible



DTC P0630



- VIN Not Programmed or Mismatched - Engine Control Module (ECM)



DTC P06D1



- Control Module Ignition Coil System Circuitry Performance



DTC P160D



- Incorrect Engine Calibration Detected



DTC P160E



- Engine Calibration Monitoring Not Programmed



DTC P161C



- Tire Size Not Programmed



DTC P2610



- Control Module Ignition Off Timer Performance



Circuit/System Description



This diagnostic applies to internal microprocessor integrity conditions within the engine control module (ECM). This diagnostic also addresses if



the ECM is not programmed, or is programmed incorrectly.



Conditions for Running the DTC



P0602, P0603, P0604, P0605, P0610, P0614, P0630, P160D, P160E, P161C



These DTCs run continuously when the ignition is ON.