Saturday, January 18, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1566

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1566



P0712, P0713



The automatic transmission fluid temperature is between 20-150掳C (68-302掳F) for 10 s or more.



Diagnostic Aids



A correct transmission fluid level is required for a proper function. The automatic transmission fluid temperature sensor is located inside the



transmission at the valve body. To ensure that the shown oil temperature is correct, measure the oil temperature with an external thermometer.



Reference Information



Schematic Reference



Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams/Electrical



Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Transmission Component and System Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and



Operation/AF40-6 - Automatic Transmission/Transmission Component and System Description)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Perform the Transmission Fluid Level and Condition Check (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing



and Inspection/Symptom Related Diagnostic Procedures/AF40-6 - Automatic Transmission/Transmission Fluid Level and Condition Check)



to verify correct fluid level.



2. Engine idling at operating temperature, observe the scan tool Transmission Fluid Temperature parameter. The reading should be between -40



to +215掳C (-40 to +488掳F) and change.



3. Operate the vehicle at about 60 km/h (37 MPH) for 10 min. Verify the scan tool Transmission Fluid Temperature parameter varies by more



than 2掳C (3.5掳F) to verify that the sensor is not stuck.



Circuit/System Testing



Operate the vehicle within the conditions for running and setting the DTC to verify the DTC does not reset. You may also operate the vehicle



within the conditions that you observed from the Freeze Frame/Failure Records data.



Component Testing



Static Test



1. Ignition OFF, remove the K71 Transmission Control Module.



2. Ignition OFF, test for infinite resistance between the low reference circuit terminal 7 X2 and ground.



瀚慖f less than the specified range, replace the wiring harness.



3. Ignition OFF, test for infinite resistance between the signal circuit terminal 8 X2 and ground.



瀚慖f less than the specified range, replace the wiring harness.



4. Test for infinite resistance between each terminal and the low reference circuit terminal 7 X2 and also to the signal circuit terminal 8 X2.