2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1535
relay ON, ignition voltage is supplied to several fuses in the underhood fuse block.
The ignition 1 voltage that is supplied to the ECM through the ETC fuse provides power to the internal ECM circuits associated with the throttle
actuator control (TAC) operation. The ECM also monitors the voltage level on the ignition 1 voltage circuit to confirm that the powertrain relay
contacts have closed.
Conditions for Running the DTC
P0685, P0686, and P0687
* The ignition voltage is between 10-18 V.
* The engine speed is greater than 80 RPM.
* The powertrain relay has been commanded ON and OFF.
* The DTCs run continuously once the above condition is met.
P0689 and P0690
* The ignition voltage is between 10-18 V.
* The ignition is ON.
* The DTCs runs continuously once the above condition is met.
Conditions for Setting the DTC
P0685, P0686, and P0687
The commanded state of the driver and the actual state of the control circuit do not match for greater than 4 s or for a cumulative of 30 s.
P0689 and P0690
The ECM detects that powertrain relay feedback voltage is less than 6 V for greater than 1 s, when the powertrain relay is commanded ON or OFF.
The condition exists for 4 s, or for a cumulative of 30 s.
Action Taken When the DTC Sets
DTCs P0685, P0686, P0687, P0689, and P0690 are Type C DTCs.
Conditions for Clearing the MIL/DTC
DTCs P0685, P0686, P0687, P0689, and P0690 are Type C DTCs.
Diagnostic Aids
* This test procedure requires that the vehicle battery has passed a load test and is completely charged. Refer to Battery Inspection/Test (See:
Starting and Charging/Testing and Inspection/Component Tests and General Diagnostics/Battery Inspection/Test).
* An open in the relay control circuit will cause no communication with the ECM when the ignition switch is cycled OFF and then ON after
the initial failure. The malfunction indicator lamp (MIL) will flash rapidly and other relays can be heard turning on and off with the ignition
ON.
* When disconnecting electrical connectors or removing fuses and relays from a fuse block, always inspect the component electrical terminals
for corrosion and the mating electrical terminals for tightness.
* Use the J 35616 Connector Test Adapter Kit for any test that requires probing the underhood fuse block terminals, component wire harness
terminals, or the ECM wire harness connector terminals.
Reference Information
Schematic Reference
* Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls
Schematics (LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)
* Power Distribution Schematics (See: Diagrams/Electrical Diagrams/Starting and Charging/Power and Ground Distribution/System
Diagram/Power Distribution Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Electrical Center Identification Views (See: Maintenance/Fuses and Circuit Breakers/Fuse/Application and ID)
* Probing Electrical Connectors (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Circuit Testing/Probing Electrical Connectors)
