2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 2027
- Control Module Communication Bus Off
DTC U0073 71
- ECU HS Bus Off
DTC U0073 72
- ECU LS Bus Off
DTC U2100 00
- Controller Area Network (CAN) Bus Communication
DTC U2100 47
- Controller Area Network (CAN) Bus Communication
Circuit/System Description
The serial data circuits are serial data buses are used to communicate information between the control modules. The serial data circuits also connect
directly to the data link connector (DLC).
Conditions for Running the DTCs
* Supply voltage at the control modules is in the normal operating range.
* The vehicle power mode requires serial data communications.
Conditions for Setting the DTC
The control module setting the DTC has attempted to establish communications on the serial data circuits more than 3 times in 5 seconds.
Action Taken When the DTCs Sets
* The control module suspends all message transmission.
* The control module uses default values for all parameters received on the serial data circuits.
* In the TCM, DTC U0073 will cause the transmission to go into default gears.
* In the ECM and TCM, DTC U0073 will cause the malfunction indicator lamp (MIL) to illuminate.
* The control module inhibits the setting of all other communication DTCs.
Conditions for Clearing the DTC
* The ECM/TCM modules turn OFF the MIL after 4 consecutive ignition cycles that the diagnostic runs and does not fail.
* A current DTC clears when the malfunction is no longer present.
* A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction.
Circuit/System Verification
1. Refer to Data Link References (See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and
Inspection/Initial Inspection and Diagnostic Overview) to determine which serial data system is used for a specific control module.
2. This DTC cannot be retrieved with a current status. Diagnosis is accomplished using the symptom. Refer to Symptoms - Data
Communications (See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Symptom Related
Diagnostic Procedures/Symptoms - Data Communications).
U0074
DTC U0074
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC U0074 00
- Control Module Communication Bus B Off
Diagnostic Fault Information
