Monday, March 9, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1606

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1606



programming.



* Perform the Transmission Adaptive Functions (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and



Operation/AF40-6 - Automatic Transmission/Transmission Adaptive Functions).



P0736



DTC P0736



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC P0736



- Reverse Ratio Incorrect



Diagnostic Fault Information



Circuit/System Description



The shift control solenoid assembly (SLC1, SLC2, SLC3, SLB1) and the line pressure control solenoid (SLT) are installed on the front valve body.



The solenoids linearly control hydraulic pressure in response to signals output from the transmission control module (TCM). SLC1, SLC2, SLC3,



SLB1 controls hydraulic pressure to the clutches (C1, C2, C3) and brake (B1) for smooth shifting. According to each shift control solenoid



assembly, the transmission shifts from 1st gear into 6th gear and vice versa. As a fail-safe function, if any shift control solenoid assembly



abnormality occurs, the TCM will disable the current to the solenoids.



Conditions for Running the DTC



* The ignition voltage is 10.2-15.5 V.



* The engine speed is greater than 400 RPM for 2 s.



* The transmission is not in emergency mode.



* TCM communication is normal.



* Transmission fluid temperature is higher than 20掳C (68掳F).



* DTCs P0716. P0717, P0721 and P0722 are not set.



Conditions for Setting the DTC



* Driving in Reverse gear.



* Output speed more than 500 RPM.



* Throttle position more than 10%.