2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1610
P06B1 or P06B4
The reference voltage is less than 12 V for 1 second.
P06B2 or P06B5
The reference voltage is greater than 18 V for 1 second.
Action Taken When the DTC Sets
* DTCs P06B1, P06B2, P06B4 and P06B5 are Type B DTCs.
* The PIM commands the battery energy control module (BECM) to open the high voltage contactor relays.
Conditions for Clearing the DTC
DTCs P06B1, P06B2, P06B4 and P06B5 are Type B DTCs.
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Circuit/System Verification
1. Clear the DTC information.
2. Turn the ignition OFF for 1 minute.
3. Turn the ignition ON.
4. Retest for DTCs P06B1, P06B2, P06B4 and P06B5.
Circuit/System Testing
1. Clear the DTC and operate the vehicle under the condition for running and setting the DTC.
2. Shut the ignition OFF for 30 seconds, and verify that the DTC does not reset.
瀚慖f the DTC resets, replace the PIM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for PIM replacement, setup, and programming.
P06B2
DTC P06B1, P06B2, P06B4, or P06B5
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P06B1
- Sensor Positive Voltage Circuit 1 Low Voltage
DTC P06B2
- Sensor Positive Voltage Circuit 1 High Voltage
DTC P06B4
- Sensor Positive Voltage Circuit 2 Low Voltage
