2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2358
solenoid increases line PC solenoid oil pressure by closing OFF the solenoid exhaust port. Increasing the current to the line PC solenoid decreases
line PC oil pressure by opening the solenoid exhaust port. Line PC solenoid power is supplied by the TCM through a high side driver (HSD). The
HSD protects the circuit and components from excessive current flow. If excessive current flow is detected, the HSD will turn OFF. When the fault
is corrected the HSD will reset.
Conditions for Running the DTC
P0961, P0962, or P0963
* The engine speed is greater than 500 RPM for 5 seconds.
* The ignition voltage is 8.6 volts or greater.
* DTCs P0961, P0962 or P0963 are not set.
Conditions for Setting the DTC
P0961
The TCM detects an internal electrical malfunction of the line PC solenoid where the measured line PC solenoid current does not equal the
commanded line PC solenoid current for 5 seconds.
P0962
The TCM detects a short to ground or an open/high resistance on the line PC solenoid control circuit for 1 second.
P0963
The TCM detects a short to voltage on the line PC solenoid control circuit for 1 second.
Action Taken When the DTC Sets
P0961
* DTC P0961 is a Type A DTC.
* The TCM freezes transmission adaptive functions.
P0962
* DTC P0962 is a Type A DTC.
* The TCM turns the high side driver OFF.
* The TCM defaults the transmission to 3rd gear if the current gear is 1st, 2nd, or 3rd, or 5th gear if the current gear is 4th, 5th, or 6th gear.
* The TCM inhibits the torque converter clutch (TCC).
* The TCM commands maximum line pressure.
* The TCM freezes transmission adaptive functions.
P0963
* DTC P0963 is a Type C DTC.
* The TCM freezes transmission adaptive functions.
* The TCM commands maximum line pressure.
Conditions for Clearing the DIC/DTC
* DTCs P0961 and P0963 are Type C DTCs.
* DTC P0962 is a Type A DTC.
Reference Information
Schematic Reference
Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)
Connector End View Reference
* Component Connector End Views (See: Diagrams/Connector Views)
* Inline Harness Connector End Views (See: Power and Ground Distribution/Multiple Junction Connector/Diagrams)
Description and Operation
* Transmission General Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/6L45/6L50/6L80/6L90 - Automatic Transmission/Transmission General Description)
* Transmission Component and System Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/6L45/6L50/6L80/6L90 - Automatic Transmission/Transmission Component and System Description)
* Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/6L45/6L50/6L80/6L90 - Automatic Transmission/Electronic Component Description)
Electrical Information Reference
