Wednesday, December 2, 2020

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2539

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2539

DTC P2714 or P2715

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P2714

- Clutch Pressure Control (PC) Solenoid 4 - Stuck Off

DTC P2715

- Clutch Pressure Control (PC) Solenoid 4 - Stuck On

Circuit/System Description

The clutch pressure control (PC) solenoid 4 is part of the control solenoid valve assembly, which has no serviceable parts. The PC solenoid 4

regulates transmission fluid pressure to the 2-6 clutch regulator valve which controls pressure to the 2-6 clutch. The TCM calculates gear ratio

based on the RPM signals from the input speed sensor (ISS) and the output speed sensor (OSS). The TCM compares the expected transmission gear

ratio to the calculated gear ratio for each commanded gear.

Conditions for Running the DTC

P2714

* DTCs P0716, P0717, P0722, P0723, P1825, or P1915 are not set.

* The transmission input shaft speed is greater than 60 RPM.

* 2-6 clutch is commanded ON.

P2715

* DTCs P0716, P0717, P0722, P0723, P1825, or P1915 are not set.

* The transmission output shaft speed is greater than 200 RPM.

* 2-6 clutch is commanded OFF.

Conditions for Setting the DTC

P2714

The TCM detects an incorrect on-coming clutch gear ratio, or flare, when the 2-6 clutch is commanded ON for 0.5 seconds and the transmission

input shaft speed is greater than 75 RPM from the anticipated input shaft speed.

P2715

The TCM detects an incorrect off-going clutch gear ratio, or tie-up, when the 2-6 clutch is commanded OFF for 0.5 seconds and the transmission

input shaft speed is greater than 40 RPM from the anticipated input shaft speed.

Action Taken When the DTC Sets

* DTCs P2714 and P2715 are Type A DTCs.

* The TCM commands maximum line pressure.

* The TCM inhibits TCC.

* The TCM freezes transmission adaptive functions.

Conditions for Clearing the DIC/DTC

DTCs P2714 and P2715 are Type A DTCs.

Diagnostic Aids

Before performing a road test, configure and setup the scan tool for snapshot mode. This will allow you to display, monitor, and verify multiple

transmission data parameters at one time, after the road test.

Reference Information

Connector End View Reference