2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2575
瀚慖f the reading is not within the specified range, replace the Q8 control solenoid valve assembly.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for Q8 control solenoid valve assembly replacement,
setup, and programming.
2ML70 - Automatic Transmission
DTC P2728-P2730
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P2728
- Pressure Control (PC) Solenoid 5 System Performance
DTC P2729
- Pressure Control (PC) Solenoid 5 Control Circuit Low Voltage
DTC P2730
- Pressure Control (PC) Solenoid 5 Control Circuit High Voltage
Diagnostic Fault Information
Circuit/System Description
The clutch pressure control solenoid 5 is part of the control solenoid valve assembly and is not serviced separately. The transmission control
module supplies 12 volts to the PC solenoid 5 through the high side driver 1 circuit. The transmission control module controls the clutch pressure
control solenoid 5 through the clutch pressure control solenoid 5 control circuit. The normally low clutch pressure control solenoid 5 flows fluid to
the actuator feed limit valve when commanded ON and exhausts fluid when commanded OFF. The clutch pressure control solenoid 5 regulates the
transmission fluid pressure from the auxiliary transmission fluid pump in order to maintain transmission fluid pressure during electric only and
auto-stop modes.
Conditions for Running the DTC
* The engine run time is greater than 5 seconds.
* The vehicle speed is less than 200 km/h (124 mph) for 5 seconds.
* The system voltage is 11-18 V.
Conditions for Setting the DTC
P2728
The transmission control module detects an internal electrical performance malfunction of the clutch pressure control solenoid 5 control circuit
when the actual pressure does not equal the commanded pressure for 5 seconds.
Diagnostic Repair parts ,Wiring Diagrams. DTC. TSB,Car, Truck, SUV & Van Acura Chrysler Infiniti Maserati Rolls-Royce Alfa Romeo Dodge Jaguar Mazda Scion Aston Martin Ferrari Jeep McLaren Smart Audi Fiat Karma Mercedes-Benz Spyker BMW Ford Kia Mini Subaru Bentley Freightliner Lamborghini Mitsubishi Tesla Bugatti GMC Land Rover Mobility Ventures Toyota Buick Genesis Lexus Nissan Volkswagen Cadillac Honda Lincoln Porsche Volvo Chevrolet Hyundai Lotus Ram
Friday, December 4, 2020
2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2575
Labels:
Cadillac Truck,
replace the Q8 control solenoid valve assembly.,
瀚慖f the reading is not within the specified range