Saturday, November 9, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1488

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1488

* Safety glasses with appropriate side shields when within 50 feet of the vehicle, either indoors or outdoors.

* Certified and up-to-date Class "0" Insulation gloves rated at 1000V with leather protectors.

- Visually and functionally inspect the gloves before use.

- Wear the Insulation gloves at all times when working with the high voltage battery assembly, whether the system is energized or

not.

Failure to follow the procedures exactly as written may result in serious injury or death.

1. Ignition OFF, disable the high voltage at the drive motor generator battery. Refer to High Voltage Disabling ().

2. Disconnect the X4 harness connector at the drive motor battery control module.

3. Connect to the EL-48571 high voltage battery pin out box.

4. Install the high voltage manual disconnect lever. Measure and record each of the 20 battery voltages.

5. Each battery voltage reading should be between 10-19 V.

瀚慖f not within the specified range, replace the drive motor battery assembly.

6. Each battery voltage reading should be within 1.5 V of each other.

瀚慖f not within the specified range, replace the drive motor battery assembly.

7. If all circuits test normal, replace the drive motor battery control module.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.

* Drive Motor Generator Battery Replacement and Shipping Preparation ()

* Control Module References (See: Testing and Inspection/Programming and Relearning) for drive motor generator battery control module

replacement, setup and programming

P0B97

DTC P0B3D, P0B42, P0B47, P0B4C, P0B51, P0B56, P0B5B, P0B60, P0B65, P0B6A, P0B6F, P0B74, P0B79, P0B7E, P0B83, P0B88, P0B8D,

P0B92, P0B97, or P0B9C

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0B3D

- Hybrid Battery 1 Circuit Low Voltage

DTC P0B42

- Hybrid Battery 2 Circuit Low Voltage

DTC P0B47

- Hybrid Battery 3 Circuit Low Voltage

DTC P0B4C

- Hybrid Battery 4 Circuit Low Voltage

DTC P0B51

- Hybrid Battery 5 Circuit Low Voltage

DTC P0B56

- Hybrid Battery 6 Circuit Low Voltage