2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 810
* Right Rear Sensor circuit terminal 19
瀚慖f less than the specified value, test the 12 V reference circuit for a short to ground.
5. Test for infinite resistance between the following signal circuit terminal of the appropriate sensor circuit listed below and ground.
* Left Front Sensor circuit terminal 34
* Right Front Sensor circuit terminal 6
* Left Rear Sensor circuit terminal 20
* Right Rear Sensor circuit terminal 31
瀚慖f less than the specified value, test the signal circuit for a short to ground.
6. Ignition OFF, disconnect the harness connector at the appropriate wheel speed sensor.
7. Test for less than 2 ohm between the appropriate 12 V reference circuit terminals listed below.
* Left Front Sensor circuit terminal 21 at the EBCM harness connector, and terminal 2 at the wheel speed sensor harness connector
* Right Front Sensor circuit terminal 18 at the EBCM harness connector, and terminal 2 at the wheel speed sensor harness connector
* Left Rear Sensor circuit terminal 33 at the EBCM harness connector, and terminal B at the wheel speed sensor harness connector
* Right Rear Sensor circuit terminal 19 at the EBCM harness connector, and terminal B at the wheel speed sensor harness connector
瀚慖f greater than the specified range, test the 12 V reference circuit for an open or high resistance.
8. Test for less than 2 ohm between the appropriate signal circuit terminals listed below.
* Left Front Sensor circuit terminal 34 at the EBCM harness connector, and terminal 1 at the wheel speed sensor harness connector
* Right Front Sensor circuit terminal 6 at the EBCM harness connector, and terminal 1 at the wheel speed sensor harness connector
* Left Rear Sensor circuit terminal 20 at the EBCM harness connector, and terminal A at the wheel speed sensor harness connector
* Right Rear Sensor circuit terminal 31 at the EBCM harness connector, and terminal A at the wheel speed sensor harness connector
瀚慖f greater than the specified range, test the signal circuit for an open or high resistance.
9. If all circuits test normal, replace the appropriate wheel speed sensor. If the DTC resets replace the EBCM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Front Wheel Speed Sensor Replacement
* Rear Wheel Speed Sensor Replacement
* Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, setup, and programming
Antilock Brake System - Non-Hybrid Greater than/Equal to 3900 kg (8600 lb) GVW
DTC C0035-C0050
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC C0035 02
- Left Front Wheel Speed Sensor Circuit Short to Ground
DTC C0035 05
- Left Front Wheel Speed Sensor Circuit Short to Battery or Open
DTC C0035 0F
- Left Front Wheel Speed Sensor Circuit Erratic Signal
DTC C0035 18
- Left Front Wheel Speed Sensor Circuit Signal Amplitude Less Than Minimum
