2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 751
瀚慖f not the specified value, replace the adjustable pedal switch.
3. Adjustable pedal switch in the FWD position, test for less than 2 ohms between the 12-volt reference terminal 5 and the signal terminal 6.
瀚慖f greater than the specified range, replace the adjustable pedal switch.
4. Adjustable pedal switch in the RWD position, test for less than 2 ohms between the 12-volt reference terminal 5 and the signal terminal 4.
瀚慖f greater than the specified range, replace the adjustable pedal switch.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Accessory Switch Replacement (Except Cadillac) (See: Instrument Panel, Gauges and Warning Indicators/Service and Repair/Accessory
Switch Replacement (Except Cadillac))Accessory Switch Replacement (Cadillac) (See: Instrument Panel, Gauges and Warning
Indicators/Service and Repair/Accessory Switch Replacement (Cadillac))
* Control Module References (See: Testing and Inspection/Programming and Relearning) for the MSM replacement, setup, and programming
B3606
DTC B3606
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B3606 01
- Adjustable Foot Pedal Position Sensor Circuit Short to Battery
DTC B3606 06
- Adjustable Foot Pedal Position Sensor Circuit Short to Ground or Open
Diagnostic Fault Information
Circuit/System Description
The memory seat module (MSM) monitors the location of the adjustable pedals using the adjustable pedals position sensor. The adjustable pedals
position sensor is supplied with 5-volt reference and ground circuits from the MSM. The position sensor signal circuit is referenced from ground
within the MSM. The signal voltage monitored by the MSM ranges from 0.45-4.55 volts.
Conditions for Running the DTC
System voltage to the MSM must be 9-16 volts.
Conditions for Setting the DTC
The position sensor input to the MSM is not within the 0.45-4.55 volt range.
Action Taken When the DTC Sets
Memory recall functions will be suspended.
Conditions for Clearing the DTC
