2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 786
Circuit/System Description
The electronic brake control module (EBCM) uses input from the master cylinder pressure sensor for more accurate control during a vehicle
stability enhancement system event. The master cylinder pressure sensor is internal to the brake pressure modulator valve.
Conditions for Running the DTC
* The ignition is ON.
* Ignition voltage is greater than 10 volts.
* The brake pedal is not applied.
Conditions for Setting the DTC
C012A 00, C128E or C128B
Internal sensor failure is detected.
C012A 11
Improper relearn performed
C012A 01 or C12B3
A short to battery is detected on the sensor signal circuit.
C012A 06 or C12B2
A short to ground or open is detected signal circuit.
C012A OF or C12B4
Signal is erratic and changes faster than physically allowed.
Action Taken When the DTC Sets
* The EBCM disables the ABS and vehicle stability enhancement system for the duration of the ignition cycle.
* A driver information center message and/or a warning indicator may be displayed.
Conditions for Clearing the DTC
* The condition for setting the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.
Reference Information
Schematic Reference
Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation/ABS
Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
