Saturday, December 14, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 880

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 880

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

1. Engine running, accessories OFF, measure and record the battery voltage at the 12 V battery terminals. The voltage should be between

12.6-15.0 V.

瀚慖f not within the specified range, refer to Charging System Test (See: Starting and Charging/Testing and Inspection/Component Tests

and General Diagnostics/Charging System Test).

2. Observe the scan tool EBCM Battery Voltage parameter. The reading should be between 12.6-15.0 Volts.

瀚慖f greater than the specified range, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, setup, and programming.

C12E3

DTC C126C, C126D, C12E3, or U180F

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC C126C

- Control Module Communication Bus B Off

DTC C126D

- Control Module Communication Bus B Off

DTC C12E3

- Control Module Communication Bus B Off

DTC U180F

- Control Module Communication Bus B Off

Circuit/System Description

The PTLAN serial data circuits are serial data buses used to communicate information between the control modules. The PTLAN serial data

circuits also connect directly to the data link connector (DLC) for programming purposes. If this serial data system is inoperative the modules will

still communicate with the scan tool due to other serial data systems but not with each other. Communication with the scan tool for the modules on

the PTLAN bus is through the serial data gateway module (SDGM) on the HSGMLAN serial data system.

Conditions for Running the DTCs

* Supply voltage to the modules are in the normal operating range.

* The ignition switch in any position other than START.

Conditions for Setting the DTC