Thursday, December 5, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1449

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1449



DTC P161C



- Tire Size Not Programmed



DTC P2610



- Control Module Ignition Off Timer Performance



Circuit/System Description



This diagnostic applies to internal microprocessor integrity conditions within the engine control module (ECM). This diagnostic also addresses if



the ECM is not programmed, or is programmed incorrectly.



Conditions for Running the DTC



P0602, P0603, P0604, P0605, P0610, P0614, P0630, P160D, P160E, P161C



These DTCs run continuously when the ignition is ON.



P0606



DTC P0606 runs continuously when the engine speed is greater than 1,200 RPM.



P06D1



* The engine is running.



* The engine speed is less than 5,000 RPM.



* The battery voltage is between 10-18 V.



* DTC P06D1 runs continuously when the above conditions are met.



P2610



DTC P2610 runs continuously when the engine speed is greater than 240 RPM.



Conditions for Setting the DTC



The ECM detects an internal failure or incomplete or incorrect programming.



Action Taken When the DTC Sets



* DTCs P0602, P0603, P0604, P0605, P0606, P0610, P0614, P0630, P160D, and P160E are Type A DTCs.



* DTCs P06D1 and P2610 are Type B DTCs.



* DTC P161C is a Type C DTC.



Conditions for Clearing the DTC



* DTCs P0602, P0603, P0604, P0605, P0606, P0610, P0614, P0630, P160D, and P160E are Type A DTCs.



* DTCs P06D1 and P2610 are Type B DTCs.



* DTC P161C is a Type C DTC.



Diagnostic Aids



Low voltage or a momentary loss of power or ground to the ECM may cause a DTC to set. Verify the following:



* The battery cables are clean and tight, and the battery is fully charged. Refer to Battery Inspection/Test (See: Starting and Charging/Testing



and Inspection/Component Tests and General Diagnostics/Battery Inspection/Test).



* The ECM ground circuits do not have an open or high resistance.



* The ECM power circuits do not have an open, short to ground, or high resistance.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic