Saturday, January 25, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1487

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1487



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM or fuel pump control module replacement, setup,



and programming



P0628



DTC P0627-P0629



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0627



- Fuel Pump Enable Circuit



DTC P0628



- Fuel Pump Enable Circuit Low Voltage



DTC P0629



- Fuel Pump Enable Circuit High Voltage



Diagnostic Fault Information



Circuit/System Description



The engine control module (ECM) provides ignition voltage to the fuel pump flow control module whenever the engine is cranking or running. The



control module enables the fuel pump flow control module as long as the engine is cranking or running, and ignition system reference pulses are



received. While this enable voltage is being received, the fuel pump flow control module supplies a varying voltage to the in-tank fuel pump



module in order to maintain the desired fuel line pressure.



Conditions for Running the DTC



* The engine speed is greater than 0 RPM.



* The ignition voltage is between 11-18 V.



* The DTCs run continuously when the conditions above are met.



Conditions for Setting the DTC



* The ECM detects that the commanded state of the driver and the actual state of the control circuit do not match.



* The above condition is met for a minimum of 2.5 s.



Action Taken When the DTC Sets



DTCs P0627, P0628, and P0629 are Type B DTCs.



Conditions for Clearing the DTC



DTCs P0627, P0628, and P0629 are Type B DTCs.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference