2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1125
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P162B
- Remote Vehicle Speed Limiting Signal Message Counter Incorrect
Circuit/System Description
When a remote slow-down request is sent from OnStar, the vehicle communication interface module sends a serial data message to the engine
control module (ECM) indicating that reduced vehicle speed has been requested. Once the request is active, the ECM begins reducing engine torque
to match requested vehicle speed and the REDUCED ENGINE POWER message is displayed.
Conditions for Running the DTC
* The engine run time is greater than 5 seconds.
* A remote slow-down request is sent from OnStar
Conditions for Setting the DTC
* The VIN embedded in the slow-down request does not match the VIN stored in the ECM.
* The rolling code counter embedded in the slow-down request does not increment for ten consecutive messages.
Action Taken When the DTC Sets
* ECM ignores all reduced vehicle speed request messages from the vehicle communication interface module.
* The ECM stores DTC P162B in history.
Conditions for Clearing the DTC
* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear after 40 malfunction-free ignition cycles have occurred.
Reference Information
Schematic Reference
OnStar Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/OnStar Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Remote Vehicle Speed Limiting Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description
and Operation/Remote Vehicle Speed Limiting)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Perform the scan tool Stolen Vehicle Slow-Down Clear. Verify DTC P162B is not set.
If the DTC is set, replace the vehicle communication interface module and retest. If the DTC sets again, replace the ECM.
