2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1537
Note: Depending on the application, the relay coil resistance will be within one of the following ranges.
1. Test for one of the following resistance specifications between terminals 85 and 86 of the KR75 powertrain relay:
* 70-110 ohm
* 200-250 ohm
瀚慖f not within the specified range, replace the KR75 powertrain relay.
2. Measure for infinite resistance between the following terminals of the KR75 powertrain relay:
* 30 and 86
* 30 and 87
* 30 and 85
* 85 and 87
瀚慖f continuity is detected, replace the KR75 powertrain relay.
3. Connect a 15 A fused jumper wire from the positive terminal of the battery to relay terminal 85. Connect a jumper wire from the negative
terminal of the battery to relay terminal 86. Measure for less than 2 Ohms between terminals 30 and 87 of the relay.
瀚慖f greater than the specified value, replace the KR75 powertrain relay.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Relay Replacement (Attached to Wire Harness) (See: Power and Ground Distribution/Power Distribution Relay/Service and Repair/Relay
Replacement (Attached to Wire Harness))Relay Replacement (Within an Electrical Center) (See: Power and Ground Distribution/Power
Distribution Relay/Service and Repair/Relay Replacement (Within an Electrical Center))
* Control Module References (See: Testing and Inspection/Programming and Relearning) for engine control module replacement, setup, and
programming
P0689
DTC P0685, P0686, P0687, P0689, or P0690 (LAU)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0685
- Engine Controls Ignition Relay Control Circuit
DTC P0686
- Engine Controls Ignition Relay Control Circuit Low Voltage
DTC P0687
- Engine Controls Ignition Relay Control Circuit High Voltage
DTC P0689
- Engine Controls Ignition Relay Feedback Circuit Low Voltage
DTC P0690
- Engine Controls Ignition Relay Feedback Circuit High Voltage
Diagnostic Fault Information
