2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1920
Each parameter should display OK or Not Run.
2. Engine running, observe the DTC information with a scan tool. DTC P0201, P0202, P0203, P0204, P0205, P0206, P0207 or P0208 should
not set.
3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the
conditions that you observed from the Freeze Frame/Failure Records data.
Circuit/System Testing
1. Ignition OFF, disconnect the affected fuel injector harness connector at the fuel injector.
2. Ignition ON, verify that a test lamp illuminates between the ignition voltage circuit terminal A and ground.
瀚慖f the test lamp does not illuminate, test the ignition voltage circuit for a short to ground or an open/high resistance. If the circuit tests
normal and the ignition voltage circuit fuse is open, test or replace the fuel injector.
3. Connect the J 34730-405 between the control circuit terminal B and the ignition voltage circuit terminal A.
4. Command the fuel injector ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded
states.
瀚慖f the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the engine control module
(ECM).
瀚慖f the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace
the ECM.
5. If all circuits test normal, test or replace the fuel injector.
Component Testing
Note: The engine coolant temperature (ECT) sensor must be between 10-32掳C (50-90掳F) for an accurate measurement.
Measure for 11-14 ohm between the terminals of the fuel injector.
If not within the specified range, replace the fuel injector.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Fuel Injector Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and Repair/Removal and
Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming
P0202
DTC P0201, P0202, P0203, P0204, P0205, P0206, P0207, or P0208
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0201
- Injector 1 Control Circuit
DTC P0202
- Injector 2 Control Circuit
DTC P0203
- Injector 3 Control Circuit
DTC P0204
- Injector 4 Control Circuit
