2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1219
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Special Tools
EL-48900 HEV Safety Kit
Circuit/System Verification
1. Verify that DTC P0A80, P0A81 or P0BBD is not set.
瀚慖f any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code
Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle),
2. Ignition ON, observe the scan tool BECM hybrid battery temperature parameters. The readings should be between -39 and +95掳C (-38.2 and
+203掳F) with no greater than a 15掳C ( 59掳F) difference between any of the four temperature sensor readings. Refer to Temperature Versus
Resistance ().
Circuit/System Testing
Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection.
Personal Protection Equipment (PPE) and proper procedures must be followed.
The High Voltage Disabling procedure will perform the following tasks:
* Identify how to disable high voltage.
* Identify how to test for the presence of high voltage.
* Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures
must be followed.
Before working on any high voltage system, be sure to wear the following Personal Protection Equipment:
* Safety glasses with appropriate side shields when within 50 feet of the vehicle, either indoors or outdoors.
* Certified and up-to-date Class "0" Insulation gloves rated at 1000V with leather protectors.
- Visually and functionally inspect the gloves before use.
- Wear the Insulation gloves at all times when working with the high voltage battery assembly, whether the system is energized or
not.
Failure to follow the procedures exactly as written may result in serious injury or death.
1. Ignition OFF, disable the high voltage at the drive motor generator battery. Refer to High Voltage Disabling ().
2. Verify that none of the following conditions exist:
* the inlet and outlet air vents do not have any obstructions or blockages
* the vent fan blades are not broken or damaged
* the internal foam seals are not missing or damaged
瀚慖f any conditions are found, remove, repair or replace as necessary.
3. Ignition OFF, disconnect the X3 harness connector at the drive motor generator battery control module.
4. Test for 1k ohm-209k ohm between each of the terminals listed below. The resistance of each temperature sensor should be within the
specified range, and within 500 ohm of each other. Refer to Temperature Versus Resistance ().
* Sensor 1-5 V reference circuit terminal 1 and low reference circuit terminal 2
* Sensor 2-5 V Reference circuit terminal 3 and low reference circuit terminal 4
* Sensor 3-5 V Reference circuit terminal 5 and low reference circuit terminal 6
* Sensor 4-5 V Reference circuit terminal 7 and low reference circuit terminal 8
瀚慖f not within the specified range, replace the drive motor battery sensor module wiring harness.
